I'm a student at Penn State and recently I've been involved with a club that focuses on developing prosthetic training devices for physically disabled kids and teenagers in the area. I've been looking for some inspiration to design a more realistic and comfortable upper limb prosthetic training device for one of our older teenagers who was born with the use of his thumb and index finger.
What are some solutions that you might have taken to achieve a similar goal? I have access to most hardware tools and 3D printers.
If you registered on or before August 25, 2017, you will need to reset your password. Your password reset confirmation will be emailed to you. If you do not receive it, please check your junk folder. Be sure to add [email protected] to your contact list so you do not miss out on important forum related emails. Disabilities-R-Us will never send you any unsolicited emails.
Discussion about anything and everything.
2 posts • Page 1 of 1